Aalborg PWE Digital - Manual (Page 78)

73
APPENDIX I
AALBORG
7 PWE Flow Meter EEPROM Variables Rev:A002 [10/01/2009]
Note: indexes 0-19 are write protected (manufacture and calibration specific data)
INDEX NAME DATA TYPE NOTES
0 BlankEEPROM[10] char[10] Do not modify. Table Revision [PROTECTED]
1 SerialNumber[20] char[20] Serial Number [PROTECTED]
2 ModelNumber[20] char[20] Model Number [PROTECTED]
3 SoftwareVer[10] char[10] Firmware Version [PROTECTED]
4 ManufReservedF1 float Manufacture Specific float data [PROTECTED]
5 ManufReservedF2 float Manufacture Specific float data [PROTECTED]
6 MeterCalFactorM float
Manufacture Assigned Number of Pulses per Gallon
[PROTECTED]
7 MeterSize float Size of the meter’s flow tube [mm] [PROTECTED]
8 ReservedText[12] char[12]
Reserved for Manufacture Specific Text Info
[PROTECTED]
9 ManufReservedF3 float Manufacture Specific float data [PROTECTED]
10 ManufReservedF4 float Manufacture Specific float data [PROTECTED]
11 ManufReservedF5 float Manufacture Specific float data [PROTECTED]
12 ManufReservedF6 float Manufacture Specific float data [PROTECTED]
13 ManufReservedUI1 uint Manufacture Specific uint data [PROTECTED]
14 ManufReservedUI2 uint Manufacture Specific uint data [PROTECTED]
15 ManufReservedUI3 uint Manufacture Specific uint data [PROTECTED]
16 ManufReservedUI4 uint Manufacture Specific uint data [PROTECTED]
17 ManufReservedSI1 int Manufacture Specific int data [PROTECTED]
18 ManufReservedSI2 int Manufacture Specific int data [PROTECTED]
19 ManufReservedSI3 int Manufacture Specific int data [PROTECTED]
20 TimeSinceCalHr float Time elapsed since last calibration in hours
21 ProtectionCode uint Program Parameters Protection Code [0-255]
22 BackLight int Back Light Level [0-4095]**
23 BackLightMode int Back Light Mode (E-Enable/D-Disable)**
24 LCD_Diagnostic uint LCD Diagnostic Mode: [0, 1]
25 Address485 char[4]
Two hexadecimal characters address for RS485
only [01-FF]
26 FlowUnits int Current Units of Measure [0-28]
27 AlarmMode uint Flow Alarm Mode (0=Disabled, 1=Enabled)
28 LowAlarmPFS float Low Flow Alarm Setting [%FS] 0-Disabled
29 HiAlarmPFS float High Flow Alarm Setting [%FS] 0-Disabled
30 AlmDelay uint Flow Alarm Action Delay [0-3600sec] 0-Disabled
31 RelaySetting char[4] Relays Assignment Setting**
32 TotalMode uint Totalizer Mode [1- Enabled, 0 - Disabled]