Chatsworth Products Hot Aisle Containment - Manual (Page 27)

Aisle Containment Manual, Rev. 2.0 ___ June 2013
Chatsworth Products 27
INSTALLING THE COLD AISLE ROOF SYSTEM:
BUILDING THE FRAME:
1. Open boxes and organize materials. Separate the beam sections into two sets of
equivalent length components, one for each side of the row.
2. Install foam tape to underside of beam as shown below.
3. The nominal roof lengths are minimums, each end panel allows for approximately 4”
(100mm) of increase in the aisle length. Measure the actual cabinet row length, this
measurement must be slightly larger than the ordered “nominal” roof length. Position the
end of the first beam approximately half of the difference inboard from the side panel of
the end cabinet. For example, if a row of cabinets measures 6100mm, a 6000mm roof
containment system should be deployed, and the starting beam should be positioned
50mm inboard of the end cabinet.