Chatsworth Products Hot Aisle Containment - Manual (Page 5)

Aisle Containment Manual, Rev. 2.0 ___ June 2013
Chatsworth Products 5
AISLE CONTAINMENT DOOR SYSTEM
INTRODUCTION TO THE AISLE CONTAINMENT DOOR SYSTEMS
The Aisle Containment Door Systems from Chatsworth Products, Inc. (CPI) have been
developed to meet a wide range of application needs. The door systems can be
installed in aisle widths that are between two and three tiles wide. The door systems
are designed to be compatible with F-Series TeraFrame
® and GF-Series GlobalFrame®
cabinets that are between 42U minimum and 52 U maximum height (77.8” – 98.9”).
Door systems are available in three sliding options including: double-door, single-door
left-hand sliding and single-door right-hand sliding. Four finish options are available
including black and glacier white colors with either anodized aluminum door frames or
color-matched door frames. The system can be installed onto slab floors or raised
access floors. All systems include a stylish anodized aluminum door frame with full-
height, clear polycarbonate inserts, an automatic close system with speed control
damper, and a detent-open catch.
SAFETY INFORMATION
WARNING: Improper use of this product may lead to serious injury or death.
Read and understand all instructions for proper installation and use of this
product.
Installation of Aisle Containment Products may require the use of ladders,
scaffolds, and other climbing tools. Follow all climbing device procedures and
observe all safety and warning precautious.
The Aisle Containment Door components are heavy and large. This requires that
at least two personnel be used for assembly and installation. Obtain adequate
assistance or hire professional equipment riggers.
INTENDED USE
• Install the doors only in a restricted service environment, such as a data center.
Use indoors only, in environmentally controlled areas; do not use outdoors, in
harsh environments, or in air-handling spaces. Not for use in plenums.
STORAGE OF COMPONENTS
• Aisle Containment Components should be stored indoors only in environmentally
controlled areas. Do not store outdoors. Do not expose to harsh or humid areas.
TOOLS REQUIRED FOR INSTALLATION
Utility Knife* Large Phillips screwdriver
Small Phillips screwdriver 8 mm wrench
10 mm socket wrench 12 mm socket wrench
13 mm socket and open end wrench Straight edge*
*For best results when cutting corrugated plastic sheet use specialized cutting tools, like the Guardian
Knife Guide and Coro-
Claw™ Flute Cutter by Saw Trax Mfg. Inc.