Chatsworth Products Hot Aisle Containment - Manual (Page 8)

Aisle Containment Manual, Rev. 2.0 ___ June 2013
Chatsworth Products 8
SINGLE DOOR
For the single door, position the template (PN 32875-702) with the flanges down and
oriented for left or right door opening as shown in the pictures shown below; the first picture
shows a left opening door and the second shows a right opening door. The side flange
should butt against the cabinet side and the template slots should be centered on the aisle.
Drill four holes, two at each end, through the template; the template holes are ½” diameter
which should be the correct size for 3/8” concrete anchors (not included). If possible use the
outside set of holes as shown in the picture below; the other holes can be used if there is an
obstruction in the concrete.