Chatsworth Products Hot Aisle Containment - Manual (Page 52)

Aisle Containment Manual, Rev. 2.0 ___ June 2013
Chatsworth Products 52
Q: What if there is an uneven gap between the two door assemblies.
A: Either one of both of the door assemblies is not level. Adjust the leveling nuts to level
the doors and eliminate the gap.
Q: What if the door vertical gasket stops before sealing to the vertical L shaped
bracket on the side assemblies?
A: The door(s) are not centered on the track. Loosen hardware securing door support
brackets to the trolley system. Slide door assemblies left or right as required. Re-tighten
hardware.
Q: What if the door stops before fully closing?
A: Adjust door brush seal height if too low. Door support hardware may be overtightened.
Loosen M8 hardware securing door to support brackets. Loosen leveling nuts to lower door
assembly. Check operation. If improved, tighted the M8 nuts attaching the door assembly
to the bracket finger tight then ¼ turn with a wrench.