Samsung HT-H6500WM-ZA - Manual (Page 10)

10
- English
Connections
Speaker~Cable~Connections
1.~ Match each speaker cable bundle to the correct speaker by matching the color coded plug on each
bundle to the colored sticker on the bottom or back of each speaker.
2.~ Connect the speaker wire plugs from each speaker to the back of the product by matching the
colors of the speaker plugs to the colors of the speaker jacks.
HDMI OUT
LAN
POWER
AUX IN FM ANT
OPTICAL
DIGITAL AUDIO IN
L
R
HDMI IN
SPEAKERS OUT
CENTER SUBWOOFER
FRONT L FRONT R
IMPEDANCE : 3
Ω
SPEAKERS OUT
CENTER SUBWOOFER
FRONT L FRONT R
IMPEDANCE : 3
Ω
Front Speaker (R)
Subwoofer
Center Speaker
Wireless Receiver Module
Surround
Speaker (L)
Front Speaker (L)
Surround
Speaker (R)
* This product should be connected with the SWA-6000 only.
✎ If you place a speaker near your TV set, the screen color may be distorted because of the magnetic
field.
✎ Place the wireless receiver module at the rear of the listening position. If the wireless receiver module
is too close to the product, sound from the speakers may be disrupted because of interference.
✎ If you use a device such as a microwave oven, wireless LAN Card, Bluetooth device, or any other
device that uses the 2.4/5.8GHz frequencies near the product, sound from the speakers may be
disrupted because of interference.
✎ The maximum transmission distance from the product to the wireless receiver module is about 33
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or
metallic wall is between the product and the wireless receiver module, the system may not operate
at all, because the radio waves cannot penetrate metal.
✎ If the product doesn't make a wireless connection, you need to run an ID Set between the product
and wireless receiver module. With the product turned off, press and hold (mute) button on the
remote control for 5 seconds. Turn on the wireless receiver module. Then, press and hold the "Id~
SET" button on the back of the wireless receiver module for 5 seconds, and then turn the product
on.