Samsung SC-D77-XAA - Manual (Page 65)

61
ENGLISH
Using the VIDEO LIGHT
✤ VIDEO LIGHT works in CAMERA mode only.
✤ To brighten the scene when natural lighting is too dim.
✤ VIDEO LIGHT works in SP mode only.
– If you turn on the LIGHT in LP mode, the LIGHT indicator ( ) “LP” will blink in the LCD.
Danger
■ The video light can become extremely hot.
Do not touch it either while in operation or soon after turning it off, otherwise serious injury may result.
■ Do not place the camcorder into the carrying case immediately after using the video light, since it will remain hot for some time.
■ Do not use near flammable or explosive materials.
■ It is recommended that you consult your nearest SAMSUNG authorized service center for bulb replacement.
1. Set the camcorder to the CAMERA mode.
2. Set the LIGHT switch to ON.
■ The LIGHT indicator ( ) appears in the LCD and the light is turned on.
3. If you want to turn off the VIDEO LIGHT, set the LIGHT switch to OFF.
Notes
■ The LIGHT is turned off automatically when inserting or ejecting a tape.
■ Even if the battery indicator ( ) does not blink when the battery pack’s charge is low, the camcorder may turn off automatically when you turn
on the LIGHT, or when you start recording with the LIGHT turned on.
■ The built-in light is used as a subsidiary light, it may not be enough for outdoor lighting.
■ The picture quality may deteriorate if you use the VIDEO LIGHT continuously for more than 20 minutes.
■ If you turn on the LIGHT in 1/8, 1/15, 1/30 SHUTTER modes, the manual SHUTTER mode will be switched off.
■ The SHUTTER mode does not operate when the LIGHT is on.
Advanced Recording
ON
OFF