Samsung SC-D77-XAA - Manual (Page 95)

91
ENGLISH
Troubleshooting
slow
fast
slow
no
slow
slow
slow
slow
the battery pack is almost discharged. Change to a charged one.
the battery pack is fully discharged. Change to a charged battery.
When the remaining time of the tape is about 3 minutes. Prepare a new one.
the tape reached its end. Change to a new one.
there is no tape in camcorder. Insert a tape.
the tape is record protected. If you want to record, release the protection.
the camcorder has some mechanical fault. 1. Eject the tape.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If unresolved, contact your local service
representative.
moisture condensation has formed in the camcorder. see below.
2MIN
TAPE END
TAPE
TAPE
C.EMG
D.EMG
L.EMG
R.EMG
DEW
Display Blinking Informs that... Action
Troubleshooting
✤ Before contacting a service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
Self Diagnosis Display
Moisture Condensation
✤ If the camcorder is brought directly from a cold place to a warm place, moisture may condense inside the camcorder, on the surface of the tape,
or on the lens. In this condition, the tape may stick to the head drum and be damaged or the unit may not operate correctly.
To prevent possible damage under these circumstances, the camcorder is fitted with a moisture sensor.
✤ If there is moisture inside the camcorder, “DEW” is displayed.
If this happens, none of the functions except cassette ejection will work.
Open the cassette compartment and remove the battery.
Leave the camcorder for at least two hours in a dry, warm room.