Avaya 4610SW - Manual (Page 74)

Telephone Management and Troubleshooting
74 4610SW IP Telephone User Guide
Ringing (Incoming) Tones Meaning
1 Ring -------- Call from another extension.
2 Rings ------- ------- Call from outside or the System Administrator.
3 Rings ------ ------ ------ Priority call from another extension, or from an
Automatic Callback call you placed.
Half Ring (ring-ping) --- A call is being redirected from your phone to another
because “Send All Calls” or “Call Forwarding All
Calls” is active.
Feedback (Handset) Tones Meaning
Busy --- --- --- Low-pitched, rapid tone (repeated 60 times per
minute), signifying the number dialed is in use.
Call Waiting Ringback Tone ---_ A ringback tone with lower-pitched signal at the end.
This indicates the extension called is busy and the
called party has been given a call waiting tone.
Confirmation -- -- -- Three short tone bursts. This indicates a feature
activation or cancellation was accepted.
Coverage - One short tone burst. This indicates your call will be
sent to another extension for a covering user to
answer.
Dial --------- Continuous tone indicating dialing can begin.
Intercept/Time-out -_-_-_- Alternating high and low tone indicating a dialing
error, denial of a requested service, or failure to dial
within a preset interval (usually 10 seconds) after
lifting the handset or dialing the previous digit.
Recall Dial - - - ----------- Three shorts tone bursts followed by a steady dial
tone indicate a feature request was accepted and
dialing can start.
Reorder -- -- -- -- -- -- Fast busy tone repeated every half-second
indicates all phone trunk lines are busy.
Ringback ---- ---- ---- ---- Low-pitched tone repeated 15 times a minute
indicates the number dialed is ringing.