Allied Telesis AT-DC2552XS - Manual (Page 272)

Chapter 11: Port Parameter Commands
272 Section II: Layer 2 Switching
AlignmentErrors Displays the number of received frames with
alignment errors. A frame with an alignment
error is a frame whose length is not an
increment of 8 bits.
CarrierSenseErr Displays the number of carrier sense errors
detected between frames.
UndersizePkts Displays the number of frames that are less
than 64 octets.
General counters: Transmit
Octets Displays the number of transmitted octets.
Pkts Displays the number transmitted packets.
MulticastPkts Displays the number of transmitted multicast
frames.
BroadcastPkts Displays the number of transmitted broadcast
frames.
PauseMACCtrlFrms Displays the number of transmitted PAUSE
packets.
FrameWDeferrdTx Displays the number of frames that were
transmitted successfully without causing any
collisions after their transmissions were delayed
due to carrier sense detection.
SingleCollsnFrm Displays the number of frames that caused one
collision.
MultCollsnFrm Displays the number of frames that caused
more than one collision.
LateCollisions Displays the number of frames that caused late
collisions.
ExcessivCollsns Displays the number of frames that transmission
was cancelled due to excessive collisions.
Collisions Displays the total number of collisions on the
port.
Layer 3 Counters
ifInUcastPkts Displays the number of unicast packets that
were received in the Layer 3 interface.
Table 45. SHOW PLATFORM PORT COUNTERS Command (Continued)
Parameter Description