Allied Telesis AT-DC2552XS - Manual (Page 288)

Chapter 12: LACP Commands
288 Section II: Layer 2 Switching
SHOW ETHERCHANNEL
Syntax
show etherchannel id_number
Parameter
id_number
Specifies the ID number of an LACP trunk group.
Mode
Privileged Exec mode
Description
Use this command to display information about trunk groups and the
specific LACP trunk group on the switch. When you do not specify the ID
number of an LACP trunk group, the command displays information about
trunk groups and all the LACP trunk groups on the switch. See Figure 51
for an example of the command output.
Figure 51. SHOW ETHERCHANNEL Command
% LAG Maximum :32
% LAG Static Maximum :32
% LAG Dynamic Maximum :32
% LAG Static Count :3
% LAG Dynamic Count :2
% LAG Total Count :5
% LAG Aggregator :po2
% Load-Balancing :MACBoth
% Member:
% port1.0.13
% port1.0.14
% LAG Aggregator:
po1
% Load-Balancing: MACBoth
% Member:
% port1.0.25
% port1.0.26
% port1.0.27
% port1.0.28