Allied Telesis AT-S83 - Manual (Page 45)

45
Chapter 4
View Mode Commands
This chapter provides a description of the commands that are available
from the View mode. These commands permit basic configuration of the
switch. All of the following commands are also available in the Privileged
Executive mode.
This chapter contains the following commands:
ˆ “CLEAR ARP-CACHE” on page 46
ˆ “CLEAR IP” on page 47
ˆ “CLEAR MAC ADDRESS-TABLE” on page 48
ˆ “CLEAR SPANNING-TREE DETECTED PROTOCOLS” on page 49
ˆ “DEBUG DOT1X” on page 50
ˆ “DEBUG MSTP” on page 52
ˆ “DEBUG RIP” on page 53
ˆ “DEBUG RSTP” on page 54
ˆ “DEBUG SNMP” on page 55
ˆ “DEBUG STP” on page 56
ˆ “ENABLE” on page 57
ˆ “EXIT” on page 58
ˆ “HELP” on page 59
ˆ “LOGOUT” on page 60
ˆ “QUIT” on page 61
ˆ “SHOW INTERFACE SWITCHPORT” on page 62
ˆ “SHOW RUNNING-CONFIG” on page 64