A.J. Antunes & Co UF-216CC 9700407 - Manual (Page 12)

UF-216CC water Filtration system
12
A.J. Antunes & Co.
P/N 1011135 Rev. A 03/12
InstallatIOn (continued)
figure 4. replacing the carbon cartridge
carbon
Housing
carbon
cartridge
Installing and rinsing the carbon element
The Carbon element MUST be rinsed before using the
system the first time.
1. Install the new Carbon Element into the Carbon
Element Housing.
2. Screw the Carbon element housing (containing
the Carbon Element) into place on the Carbon
Element Head. The housing will come to a hard
stop at the end of the thread. Use a Filter Wrench
if necessary.
nOte: Do nOt overtighten the carbon element
Housing.
3. Direct water from the Permeate Outlet to a drain.
4. Turn on the water to the system by slowly opening
the inlet water valve.
5. Allow water to flow through the Carbon Element
and Carbon Element Housing to flush out trapped
air and any debris that may be present.
6. To help remove trapped air from the Carbon
element housing, press the ReD Pressure Relief
Button on the top of the housing until water just
begins to come out.
7. Rinse the Carbon Element for at least 5 minutes.
nOte: Do nOt consume water used during this
process.
8. The system is now ready for use.