Allied Telesis AR700 Series - Manual (Page 14)

Features in 275-04 14
Version 275-05
C613-10473-00 REV D
CR00008699 Switch 2 Previously, when 300 MAC address filters were added to a port and the port was
reset, the CPU became 100% utilised.
This issue has been resolved.
- - - Y Y Y - - - -
CR00008742 Switch 2 Previously, if a switch port’s learn limit was changed to a number that was less
than the currently-learned number of MAC addresses, you were unable to delete
the learned MAC addresses. The switch also did not lock the port.
This issue has been resolved. The switch now deletes all learned MAC addresses
and starts learning again.
- - - Y Y Y - Y Y Y
CR00009402 Firewall 2 The firewall SMTP proxy did not proxy SMTP sessions to certain servers that used
long fully-qualified domain names. Sessions to such servers were not established.
This issue has been resolved. The proxy now correctly opens sessions to such
servers.
Y Y Y Y Y - - - - Y
CR00010265 Switch 2 When the ingress and egress port were defined in an Layer 3 filter with an action
of deny, the filter denied the traffic to be sent out all the egress ports and not
just the egress port specified in the filter.
This issue has been resolved.
- - - Y Y Y - - - -
CR00010443 Bridge 2 When the router or switch interface is configured as part of a bridged STP
network, and the interface is in a blocking state, BPDUs transmitted out that
interface sometimes had the “Topology change” flag set even though the
topology had not changed. This caused the attached device to cycle its port states
from listening to learning to blocking to listening. Y Y Y Y - - - - - -
CR00010598 OSPF 2 When filtering OSPF routes, IP route filters did not filter out intra-area interface
routes.
This issue has been resolved.
Y Y Y Y Y Y - Y Y Y
CR Module Level Description A
R
400
A
R
7x5
A
R
750
S
Ra
p
ie
r
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T
-87
00X
L
AT
-8
9
4
8
AT
-9
9
0
0
AT
-9
8
0
0