Allied Telesis AR700 Series - Manual (Page 17)

Features in 275-04 17
Version 275-05
C613-10473-00 REV D
CR00011587 Switch 2 Previously, if a port was a tagged member of a VLAN, it was not able to transmit
untagged frames to that VLAN.
This issue has been resolved. When required, STP BPDUs can now to be sent
untagged out a port, even if the port is configured as a tagged member of a
VLAN.
- - - - - - - Y Y -
CR00011645 Switch 2 After an AT-8800 series switch was powered down or rebooted, non auto-
negotiating copper GBICs did not correctly handle Ethernet PAUSE frames.
This issue has been resolved.
- - - - Y - - - - -
CR00011666 CORE 2 AR745 routers sometimes had a high CPU utilisation after restarting, although
they were idle.
This issue has been resolved.
- Y - - - - - - - -
CR00011727 UPNP 2 Deleting a firewall policy that UPnP was using could cause the router to reboot. Y Y Y - - - - - - -
CR00011746 BGP 2 If the router or switch failed to establish a BGP peer session because of
unsuccessful Open message exchanges, no further attempts to establish the peer
connection were made.
This issue has been resolved. The router or switch now continues to attempt to
establish the session, with 60 second intervals between attempts.
Y Y Y Y Y - - Y Y Y
CR00011780 BOOTP 2 Previously, if a user entered the command set bootp relay option82
port=portnum without also specifying one of the required subscriberid or
trusted parameters, the router or switch would incorrectly report “Operation
Successful”.
This issue has been resolved. The router or switch now reports that one of the
parameters subscriberid or trusted must also be specified as part of this
command.
Y Y Y Y Y Y - Y Y Y
CR Module Level Description A
R
400
A
R
7x5
A
R
750
S
Ra
p
ie
r
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T
-87
00X
L
AT
-8
9
4
8
AT
-9
9
0
0
AT
-9
8
0
0