Adaptec SBC-599 - Manual (Page 81)

Chapter 6 SCSI Setup and Configurations 71
Basic Host Adaptec Settings Default
Host Adapter SCSI ID 7
SCSI Parity Checking Enabled
Host Adapter SCSI Termination Low ON/High ON
Boot Device Settings Default
Boot Target ID 0
Boot LUN Number 1 0
SCSI Device Settings Default
Initiate Sync Negotiation Yes (Enabled)
Maximum Sync Transfer Rate Yes (Enabled)
Enable Disconnection 20 MBytes/sec
Initiate Wide Negotiation Yes (Enabled)
Send Start Unit Command No (Disabled)
Advanced Host Adapter Settings Default
Plug and Play SCAM Support Disabled
Host Adapter BIOS Enabled
Support Removable Disks Under BIOS as Fixed Disks 2 Boot only
Extended BIOS Translation for DOS Drives >1 GByte 2 Enabled
Display <Ctrl-A> Message During BIOS Initialization 2 Enabled
Multiple LUN Support Disabled
Support for Ultra SCSI Speed Disabled
1. Setting is valid only if multiple LUN Support is enabled.
2. Settings are valid only if host adapter BIOS is enabled.
Basic Host Adapter Settings
The basic host adapter settings are the SCSISelect settings most
likely to require any modification.
n
Host Adapter SCSI ID - This option sets the host adapter’s
SCSI ID. The default setting is SCSI ID 7, which give the