Sony MVC-CD400 - Manual (Page 14)

model name1[MVC-CD400/CD250]
[3-075-356-12(1)]
14
filename[C:\MVC-CD400Nouhinn\3075356121\307535612MVCCD400U2\03bas.fm]
masterpage:Left
, Connect the power cord (mains
lead) to the AC power adaptor
and then to a wall outlet (wall
socket).
The /CHG lamp (orange) lights up when
charging begins, and goes off when
charging is completed. After charging the
battery pack, disconnect the AC power
adaptor from the DC IN jack of your
camera.
• We recommend charging the battery pack in an
ambient temperature of between 10°C to 30°C
(50°F to 86°F).
• Charging is complete in approximately 150
minutes. The charge lamp may remain lit
longer than 150 minutes, but this is not a
malfunction.
• If sufficient battery remaining time is indicated
but the power runs out soon, fully charge the
battery pack so that the correct battery
remaining time appears.
To remove the battery pack
Open the battery cover. Slide the battery
eject lever in the direction of the arrow, and
remove the battery pack.
• Be careful not to drop the battery pack when
removing it.
4
Power cord
(mains lead)
AC power adaptor
(supplied)
2 To wall outlet
(wall socket)
1
Battery eject lever
Battery remaining indicator
The battery remaining indicator on the LCD
shows the remaining shooting or viewing
time.
• When charging, the battery remaining
indicator shows the time remaining in terms
of performing continuous shooting (with all
indicators on).
• The displayed time remaining may not be
correct under certain circumstances or
conditions.
Charging time
Approximate time to charge a completely
discharged battery pack using the AC-L10A/
L10B AC power adaptor at a temperature of
25°C (77°F).
Battery pack Full charge
(min.)
NP-FM50 (supplied) Approx. 150
640
4
60min