Sony MVC-CD400 - Manual (Page 16)

model name1[MVC-CD400/CD250]
[3-075-356-12(1)]
16
filename[C:\MVC-CD400Nouhinn\3075356121\307535612MVCCD400U2\03bas.fm]
masterpage:Left2:1
Using an external power source
, Open the DC IN jack cover and
connect the DC connecting
cable to the DC IN jack of your
camera.
Connect the cable with the v mark facing
up.
• Connect the AC power adaptor to an easily
accessible wall outlet (wall socket) close by. If
some trouble occurs while using the adaptor,
immediately shut off the power by
disconnecting the plug from the wall outlet
(wall socket).
• Remove the battery pack when using an
external power source.
, Connect the power cord (mains
lead) to the AC power adaptor
and then to a wall outlet (wall
socket).
• When you have finished using the AC power
adaptor, disconnect it from the DC IN jack of
the camera.
• To use power from an automobile, use the Sony
DC adaptor/charger (not supplied).
• If you insert or remove the DC plug while you
are using the battery, the power may shut off.
1
DC IN jack cover
AC power adaptor (supplied)
DC connecting
cable
2
2 To wall outlet (wall socket)
Power cord
(mains lead)
1
AC power adaptor
(supplied)
Using your camera
abroad
Power sources
You can use your camera in any country or
area with the supplied battery charger
within 100 V to 240 V AC, 50/60 Hz. Use a
commercially available AC plug adaptor
[a] , if necessary, depending on the design of
the wall outlet (wall socket) [b] .
• Do not use an electronic transformer (travel
converter), as this may cause a malfunction.
AC-L10A/L10B