Sony MVC-CD400 - Manual (Page 20)

model name1[MVC-CD400/CD250]
[3-075-356-12(1)]
20
filename[C:\MVC-CD400Nouhinn\3075356121\307535612MVCCD400U2\04bas.fm]
masterpage:Left
Inserting a disc
, Open the disc cover.
While sliding the lock tab to the left, slide
down the disc cover OPEN lever, and open
the disc cover.
• You can use only 8 cm CD-R/CD-RW
discs that have these marks.
, Place a disc in the disc tray.
Place the disc with the printed side up, and
push down on the center of the disc until it
clicks.
• Do not push with too force on the disc.
• Do not touch the pickup lens.
, Close the disc cover.
• When the ACCESS lamp is lit up, it
means that image data is being read or
written. Never open the disc cover or
turn off the power at this time, as the
image data may be damaged or the disc
may become unusable.
• While the camera is writing data on a disc, the
disc cover OPEN lever is locked.
• After you change the disc, “REPAIRING
DATA” may appear on the LCD screen and it
may take about 10 minutes to prepare the disc
for recording depending on the disc condition.
1
Disc cover
OPEN lever
Lock tab
2
Pickup lens
Push here
Disc
Removing the disc
While sliding the lock tab to the left, slide down
the disc cover OPEN lever, and open the disc
cover. Check to make sure that the disc has
completely stopped rotating, then remove the disc.
3
Shooting still images