Sony MVC-CD400 - Manual (Page 47)

model name1[MVC-CD400/CD250]
[3-075-356-12(1)]
filename[C:\MVC-CD400Nouhinn\3075356121\307535612MVCCD400U2\07bas.fm]
masterpage:Right
47
C
o
py
ing i
m
a
g
e
s
to y
o
ur
c
o
mput
e
r
Using the supplied 8 cm CD adaptor
, Slide the disc into the inner
groove and under two of the
tabs on the inner circle of the
adaptor in the order shown by
the numbers.
If your disc drive does not support 8 cm
CD, use the supplied 8 cm CD adaptor.
• The supplied adaptor may not be compatible
with your disc drive. For details, see the
operating instructions for the disc drive.
• Use the adaptor at a low speed (8×-speed or
less).
• The reverse side of the disc is the recordable
surface.
• “SONY” is printed on the reverse side of the
adaptor and the surface is lustrous.
, Pull the third tab to the outside
and slip the disc into place.
Release the third tab and the
disc will be held firmly in place.
• Do not expose the adaptor to direct sunlight or
heat sources.
• The adaptor can be used only with Mavica
discs. It cannot be used with other 8 cm CD-R/
CD-RW.
, Check that the disc is set
correctly in the grooves of the
adaptor, all the tabs are even
with the surface of the adaptor,
and the disc does not protrude
from the adaptor.
• If the tabs protrude, press them into place, as
this may cause your disc drive to malfunction.
1
1
2
Printed side of
the disc
Printed side of
the adaptor
2 3