Sony WEGA KV-27FS100 User Manual
Page 17
9
Connecting Your TV
Cable Box and Cable
Use this connection if you subscribe to a cable system that scrambles some channels (pay channels) but
not all of them. This setup allows you to use the remote control to:
❏
change channels through your cable box when you are receiving a scrambled signal
❏
change channels through your TV
This connection also allows you to use the PIP feature when you are viewing unscrambled channels
coming directly into your TV from your cable. Scrambled signals coming through the cable box cannot
be viewed in PIP. For more information on the PIP feature, see page 20.
1
Connect the coaxial cable from your cable service to the VHF/UHF jack on your TV.
2
Using a coaxial cable (not supplied), connect the IN jack on your cable box to the TO
CONVERTER jack on your TV.
3
Using a coaxial cable (not supplied), connect the OUT jack on your cable box to the AUX jack on
your TV.
✍
Press the ANT button on the remote control to switch between the cable box and direct cable inputs.
✍
Your Sony remote control can be programmed to operate your cable box (see page 40).
✍
To use the cable box to change your channels, set your TV to channel 3 or 4. Use the Channel Fix
feature to ensure that you don’t accidentally switch channels using your TV (see page 27).
coaxial Cable
Cable Box
CATV Cable (unscrambled channels)
1
2
3
75-ohm coaxial Cable
Rear of TV