Asante Technologies FR3000 Series - Manual (Page 14)

14 Asanté FriendlyNET Cable/DSL Router
2.2 Rear Panel Information
Connect your cable or DSL modem
to the router’s WAN port. Ports 1-4
(or Ports 1 and 2 on the FR3002AL
models) are used to connect local
computers or other network de-
vices.
2.3 Installation Overview
The router must be configured to match your Internet service. If you do not know
your Internet connection configuration, please contact your Internet Service Pro-
vider (ISP).
Tip: Follow the steps in the Quick Start Guide (pages 2-5) to install and config-
ure the router.
By default, the router is pre-configured with these settings:
•
Automatically set IP addresses for computers on your LAN (connected to
the router’s ports 1-4). The router acts as a server for dynamic host configu-
ration protocol (DHCP) and assigns IP addresses in the range
192.168.123.100 through 192.168.123.199
Ports Function Specification
COM FR3004C/FR3004LC only: Dial-up
modem 9-pin D-type serial
PRINTER FR3004LC and FR3002AL models only:
Parallel printer port 25-pin D-type parallel, standard
parallel (unidirectional)
WAN Cable/DSL modem RJ-45, 10BaseT, Ethernet
1, 2, 3, 4
1, 2 (Wireless LAN ports for local computers RJ-45, 100BaseTX, 10/100 Fast
Ethernet
12 VDC Power adapter (included) 12 VDC, 1.2 A, center is positive
Wireless PC FR3002AL only: designed for AeroLAN
wireless PCMCIA cards Type II PCMCIA slot
Compare your model with the models shown above: FR3004LC
(top), FR3004C (middle), and FR3002AL (bottom).