Asante Technologies FR3000 Series - Manual (Page 79)

User’s Manual 79
F.6 Dial-up Log (for Dial-Up Network)
1.
“COM2 is in console mode”.
The COM port is in console mode. In general, the router will detect the existence
of the modem. If there is a modem attached, the COM port is available for dial-
up service immediately. Action: wait a moment or reboot the router.
2.
“COM2 start to dial-up”.
The router started to dial-up.
3.
“COM2: baud=115200”.
The baud rate to communicate with the modem was 115200.
4.
“DIAL2: tx ATZ”.
The router sent “ATZ” string to the attached modem or ISDN TA.
5. “DIAL2: rx OK”.
The router received “OK” string from the attached modem or ISDN TA.
6.
“COM2 start to hang-up”.
The router started to hang-up.
Error Cause
-303, -304 PPTP server rejects outgoing call request.
-332 Outgoing call not established – general error.
-333 Outgoing call failed due to no carrier detected.
-334 Outgoing call failed due to detection of a busy signal.
-335 Outgoing call failed due to lack of a dial tone.
-336 Outgoing call was not established within time allotted by PAC.
-337 Outgoing call administratively prohibited.