Sony ILCA-77M2 - Manual (Page 202)

decreases two images at a time.
This is because the compression rate and the image size after compression change depending on the
image when you shoot a JPEG image.
[319] Troubleshooting Troubleshooting Others
The product does not work properly.
Turn off the product. Remove the battery pack and insert it again. If the product is hot, remove the
battery pack, and allow it to cool down before trying this corrective procedure.
If an AC-PW10AM AC Adaptor (sold separately) is used, disconnect the power cord. Connect the
power cord and turn on the product again. If the product repeats the same error often or still does not
work after trying these solutions, consult your Sony dealer or local authorized Sony service facility.
[320] Troubleshooting Troubleshooting Others
“--E-” appears on the screen.
Remove the memory card, and insert it again. If the problem persists even after performing this
procedure, format the memory card.
[321] Troubleshooting Messages Messages
Warning messages
Set Area/Date/Time.
Set the area, date and time. If you have not used the product for a long time, charge the internal
rechargeable backup battery.
Power insufficient.
The cleaning mode will not operate when the remaining battery charge is less than (3). We
recommend using the AC Adaptor AC-PW20 when using cleaning mode.
Unable to use memory card. Format?
The memory card was formatted on a computer and the file format was modified. Select [Enter], and
then format the memory card. You can use the memory card again, however, all previous data in the