Inserting the battery pack into the camera [15, Inserting the battery pack into the camera – Sony ILCA-77M2 User Manual

Page 32

Advertising
background image

Light on: Charging

Light off: Charge completed

Charging time (Full charge): Approx. 175 minutes

When charging a fully depleted battery pack at a temperature of 25°C (77°F).

The CHARGE lamp

(A) turns off when charging is completed.

Note

The charging time differs depending on the remaining charge of the battery pack and on the charging

conditions.

Be sure to use only genuine Sony brand battery packs.

We recommend charging the battery pack at an ambient temperature of between 10°C to 30°C (50°F

to 86°F). You may not be able to efficiently charge the battery pack outside this temperature range.

Connect the battery charger to the nearest wall outlet (wall socket). If malfunctions occur while using

the charger, disconnect the plug from the wall outlet (wall socket) immediately to disconnect from the

power source.

Even when the CHARGE lamp of this battery charger is off, the power is not disconnected. If any

trouble occurs while this unit is in use, unplug it from the wall outlet (wall socket) to disconnect the

power.

When the camera is being used for the first time or when you use a battery pack that has not been

used for a long time, the CHARGE lamp may flash quickly when the battery is charged for the first

time. If this happens, remove the battery pack from the charger and then re-insert it to recharge.

Do not continuously or repeatedly charge the battery pack without using it if it is already fully charged

or close to fully charged. Doing so may cause a deterioration in battery performance.

[15] How to Use

Preparing the camera

Charging the battery pack

Inserting the battery pack into the camera

How to insert the battery pack into the camera

1. Slide the open lever to open the battery cover.

2. Insert the battery pack while pressing the lock lever

(A) with the tip of the battery until the battery

locks into place.

Advertising