Sony FWD-32LX2F - Manual (Page 67)

27 GB
GB
• “Display Area”, “Horizontal Shift”, “Vertical Shift”, and “Vertical Size” are not available while using the “PAP” function or
the “Multi Display”.
• If there is no signal currently being input, none of the “Screen” settings options, except for “PAP Setting” and “Multi Display”
can be selected.
Multi Display You can make settings for connecting multiple displays to form a video wall.
“Multi Display”: “Off” uses a single screen, and “2Ч2”-“4Ч4” selects the arrangement
to be used to construct the video wall.
“Position” (location popup): Select the position of this particular display in the
arrangement of the video wall with
F
/
f
/
G
/
g
. Press to set the position.
“Output Format”: Selection of two picture output formats will be available as shown
in the figures. By simply selecting either format, suitable picture output will be
available without manually adjusting the horizontal and vertical shift.
Select either “Tiles” or “Window”.
“LED”: “On” causes the POWER/STANDBY indicator on the Front Panel (page 7)
to be continually turned on, and “Off” causes the POWER/STANDBY indicator on
the Front Panel to be continually shut off.
• “Multi Display” can display an enlarged picture keeping the current “Wide Mode” setting as
much as possible for video input, and can display an enlarged picture of which “Wide Mode”
is set to “Full 2” for PC input.
• You can set the “Multi Display” only when the “PAP” function is disabled.
• When the “Position” option is set to the right-bottom, the POWER/STANDBY indicator
lights up even if the “LED” option is set to “Off”. The indicator also lights up even when the
display is off (standby) , errors are detected, or the display is in sleep mode including the
case of no signal or unsupported signal.
Notes
To show full signal on
each display. To show one large picture with
multi display naturally.
Part of the signal will go behind
the bezel area.
“Tiles”
Just scan
“Window”
Over scan
Notes