Sony FWD-32LX2F - Manual (Page 70)

30 GB
Advanced Setup “Color System”: Select the color system of video signals from “NTSC”, “PAL”,
“SECAM”, “NTSC4.43”, “PAL-M”, “PAL-N”, “PAL60”, or select “Auto” to set the
color system automatically.
“Status Display”: “On” makes input signal and “Wide Mode” information appear on
the screen for about 20 seconds when the display is turned on, and the input signal
information appear for about 5 seconds when the input signal is switched, while
“Off” disables display of status information.
Tip
You can display the input signal and “Wide Mode” information by using DISPLAY on the
remote control regardless of the “Status Display” setting.
“Illumination”: “On” enables the Sony logo on the front of the display to light up,
and “Off” disables the function.
“Control Setting”: This menu is used for settings of operation of the display and the
remote control.
“Remote Index”: You can change the “Index Number” of the display if
necessary. Select to set the “Index Number” of the display with
F
/
f
and press
to confirm the setting.
When you set the “Index Number”, use the buttons on the display. The “Index Number”
cannot be set with the remote control.
“Control Mode”
“Display+Remote”: You can operate the display with the control buttons on
the display and the remote control.
“Display Only”: Disables the remote control function. You can make
settings for the display only using the control buttons on the display.
“Remote Only”: Disables the controls on the display. You can make settings
for the display only using the remote control.
“All Off”: Disables the operation of both the remote control and the control
buttons on the display. You can operate the display via the REMOTE
connector on the display (BKM-FW20) and via the optional adaptor with
communication functions (such as BKM-FW32/FW50).
• When operating this item, the modes you can select differ depending on the button you
are using. When setting this item with on the remote control, you can select only
“Display+Remote” or “Remote Only”. When setting this item with on the display,
you can select only “Display+Remote” or “Display Only”.
• When this option is set to “All Off”, you cannot operate the display using the remote
control and the control buttons on the display. You can return the setting to
“Display+Remote” by pressing MENU and
+ on the display at the same time for
more than 5 seconds.
Information Displays the “Model Name”, “Serial Number”, “Operation Time”, “Software
Version” and “IP Address” of your display.
The “IP Address” is not shown if the optional adaptor with network functions is not installed.
All Reset Resets all the “Setup” settings to the default settings.
The items included in the “Information” option and the “Index Number” will not be reset.
Note
Notes
Note
Note