Sony FWD-32LX2F - Manual (Page 47)

7 GB
GB
Front Panel
Location and Function of Parts and Controls
1 MENU (page 20)
2 / (INPUT)
• In the menu screen, this button works as the “Set”
button.
• This button switches the input signal when it is not
in the menu screen.
Selects an input signal from among the HD15/
HDMI 1/HDMI 2/OPTION 1/OPTION 2
connectors.
When an optional adaptor is not installed in the
OPTION 1/OPTION 2 slot, OPTION 1/OPTION 2
will be skipped.
3 /
• In the menu screen, these buttons work as left/right
buttons.
• In the “PAP” mode, these buttons work to change
the active picture or change the picture size when a
screen other than the menu screen is displayed.
4 / /
• Increases (+) or decreases (
−) the volume.
• In the menu screen, these buttons work as up/down
buttons ( / ).
5 1
Switches the display on or off (standby).
To protect the panel, a certain amount of time is
required to turn the display to on/off (standby). When
you turn the display on again, soon after turning it off,
wait about 5 seconds before you turn it on again.
6 Sony logo
The Sony logo lights up.
You can switch “On”/”Off” in the menu screen.
See “Advanced Setup” on page 30.
7 Remote control sensor
8 POWER/STANDBY indicator
• Lights up in green when the display is switched on.
• Lights up in red when the display is in standby
mode.
• Lights up in orange when the display enters the
power saving mode when the current input is not
video or S Video.
When the “LED” option in the “Multi Display”
settings is set to “Off” and the “Position” option is not
set to the right-bottom, the indicator does not light up
in green even when the display is turned on, except for
the case of no signal or an unsupported signal.
Note
Note