Sony DCR-HC90 - Manual (Page 94)

94
DCR-HC90 2-548-307-11(1)
New sound added to a recorded tape is not heard.
• Adjust [AUDIO MIX] from the [ST1/FRONT] (original sound) side until the sound is heard
appropriately (p. 65).
Still pictures cannot be dubbed from a tape to a “Memory Stick Duo.”
• You cannot record or a distorted picture may be recorded if the tape has been used repeatedly
for recording.
Movies cannot be dubbed from a tape to a “Memory Stick Duo.”
• You cannot record or a distorted picture may be recorded in the following situations:
– The tape has a blank section.
– The tape has been used repeatedly for recording.
– The input signal has been interrupted or cut.
You cannot input pictures.
• You cannot input pictures while [DISP OUTPUT] is set to [V-OUT/PANEL] (p. 57).
• You cannot input pictures if you press the DISP/BATT INFO button.
Connecting to a computer
The computer does not recognize your camcorder.
• Disconnect the cable from the computer and camcorder, then connect it again securely.
• Disconnect USB devices other than the keyboard, the mouse, and the camcorder from the
computer.
• Disconnect the cable from the computer and camcorder, restart the computer, then connect
them again correctly.
An error message appears when you place the supplied CD-ROM in your
computer.
• Set the computer display as follows:
– Windows: 800 × 600 dots or more, High Color (16 bits, 65 000 colors or more)
– Macintosh: 1 024 × 768 dots or more, 32 000 colors or more
You cannot view the pictures the camcorder is seeing on the computer.
• Slide the POWER switch down to turn on the CAMERA-TAPE lamp on your camcorder,
and set [USB-CAMERA] to [USB STREAM] (p. 55). (Only when connecting to the
Windows computer with a USB cable)
• Disconnect the cable from the computer, turn on the camcorder, then connect it again.
Troubleshooting (continued)