Sony SVR-2000 - Manual (Page 48)

48 Guided Setup
filename[04 setup fm] model name1[PTV Receiver] [X XXX XXX XX (X1)]
Connection to receiver screens. If you chose satellite or cable with a set-top box
as your program source, these screens allow you to choose the cable type that you used
to connect your set-top box to your SVR Recorder. If you have multiple inputs (such as
satellite and cable), you will need to specify the cable type for each program source.
Use the UP/DOWN arrows until the picture of the SVR Recorder matches the cable
connection you used. When the Video Status says “Video OK,” press SELECT to
continue. If not, double check that the cable is firmly connected to the SVR Recorder
and that you have selected the correct cable type.
Set-top Box IR Setup screens. If you have a cable or satellite box that you have
connected with the IR Control cable, you will be guided through choosing the correct
IR codes.
Cable/Satellite Box Brand. Choose the brand name of your cable or satellite
set-top box. This narrows down the possible control codes the SVR Recorder
might use to change channels on the set-top box.
Cable/Satellite Box Channels. Choose the maximum number of digits (either
two or three) in the channel numbers that you see on your TV.
Enter Key. When you change channels on your set-top box, using your set-top
box remote, does the remote require you to press an ENTER key?
IR Checklist. This screen is a checklist for getting ready to test the SVR
Recorder’s ability to change your set-top box channels. It reminds you to double-
check your connections and a few other things.
IR Test Instructions. This screen has instructions for the IR Checklist screen.
01_COV.book Page 48 Sunday, May 26, 2002 11:46 AM