Sony SVR-2000 - Manual (Page 53)

53 Programming Your Remote Control
filename[04 setup fm] model name1[PTV Receiver]
Se
tting
Up Y
our
Sy
ste
m
Learning Mode Method
The Remote Control has the ability to “learn” codes from your TV (and/or audio
system) remote. This method works for every remote controlled TV (or stereo).
1 Put the Remote Control in learning mode.
a) Press the TiVo button and TV POWER simultaneously for 3 seconds until the
LED on the Remote Control remains lit continuously.
b) Using the number keys on the Remote Control, enter the code 0975. The Remote
Control LED flashes three times. You have 30 seconds to complete the next step.
2 Position the two remotes.
Position the TV remote and the Remote Control head-to-head about two inches
apart with their IR emitters facing each other. (The Remote Control’s IR emitter
is at the end that you point at the TV.)
3 Send the signal to the Remote Control.
a) Press the button on the Remote Control that you want to teach. For example, TV
POWER or MUTING. The Remote Control LED will flash rapidly to indicate
that it is ready to be taught. You have 4 seconds to do the next step.
b) Press the equivalent button on the TV remote. For example, if you pressed TV
POWER on the Remote Control, press the power button on the TV remote.
c) Press and hold the equivalent button on the TV remote until the Remote
Control’s LED flashes three times to indicate that it has learned the code, or
repeat this step until the LED does flash three times.
d) This step can be repeated as many times as needed.
4 Exit learning mode and test the code.
a) Press the CLEAR button on the Remote Control to exit learning mode.
b) Point the Remote Control at the TV and press the button you just taught. For
example, if you’ve just taught the TV POWER button, it should turn on the TV.
Note
• You can program the following keys with
the Learning Remote method:
TV POWER, VOL (volume) +/–, and
MUTING.
• Do not attempt this method if there is
bright fluorescent lighting or other IR
interference.
• Unlike code entry and code search, you
need to program each button individually
in learning mode.
• If you have a stereo system connected to
the SVR Recorder, you can program the
POWER button on the Remote Control to
turn on/off your stereo. To do so, use
code 1975 instead of 0975 in step 1. You
can program the POWER button to turn
on/off both your TV and your stereo.
• To reset the Remote Control back to the
manufacturer’s settings, press and hold
the TiVo and TV POWER buttons together
for three seconds until the LED on the
Remote Control remains lit. Enter code
0981 (or 1981) using the number keys on
the Remote Control.
01_COV.book Page 53 Sunday, May 26, 2002 11:46 AM