Sony SVR-2000 - Manual (Page 58)

58 Troubleshooting
filename[05 info fm] model name1[PTV Receiver] [X XXX XXX XX (X1)]
My channels aren’t changing.
(continued)
If you use a satellite set-top box with a Serial Control cable:
• Make sure the set-top box is turned on.
• Is the Serial Control cable plugged into the upper serial jack on the back of the
SVR Recorder?
• Make sure that the Serial Control cable is connected to the “low speed data” jack on
the back of the satellite set-top box.
• Unplug the satellite set-top box from the wall, then plug it back in.
If you are using an RCA satellite set-top box, use your RCA set-top box’s remote
control to specify low speed data. To do this, press the MENU button on the RCA set-
top box’s remote -> Options -> System Options -> Data Port -> Low Speed
Data.
If you use a satellite set-top box with an IR Control cable:
• Make sure the set-top box is turned on.
• Is the IR Control cable plugged into the lower IR jack on the back of the
SVR Recorder, not the cable box.
• Is the IR Emitter positioned so that it covers the IR window on your satellite box?
• Did you select a working code from the list of codes for your satellite box during
Guided Setup? To verify this, use the TiVo button to go to TiVo Central ->
Messages & Setup -> Cable/Satellite Box -> Control Cable Setup. Once
you find a code that changes your channels, press the SELECT button on the
Remote Control to choose that code.
Symptom Solution
01_COV.book Page 58 Sunday, May 26, 2002 11:46 AM