Sony MZ-N1 - Manual (Page 56)

56
On the remote control
1 Press DISPLAY for 2 seconds or more.
2 Turn the control repeatedly until “EDIT”
flashes in the display, and press x to enter.
3 Turn the control repeatedly until “Name
Bank” flashes in the display, and then press
x to enter.
4 Do steps 5 and 6 of “On the remote control”
in “Labeling recordings” (page 52) to enter a
phrase, and then press
x for 2 seconds or
more.
Note
If you have entered and then stored a phrase,
you cannot retrieve it by following the
procedure of “Searching for a phrase by
displaying the stored phrase” (page 56). When
you retrieve a stored phrase, follow the
procedure of “Searching for a phrase by its first
letter” (page 57).
Using a retrieved phrase for
labeling
There are two ways to retrieve phrases.
• Searching for a phrase by
displaying the stored phrase:
You can retrieve a phrase by displaying
the stored phrase, and then use the
phrase in a new label.
• Searching for a phrase by first
letter:
You can retrieve a phrase by its first
letter, and then use the phrase in a new
label.
Searching for a phrase by
displaying the stored phrase
On the recorder
1
Follow steps 1 and 4 of “Labeling
recordings” (page 51).
A track, group or disc is ready to be
labeled.
2
Press END SEARCH so that the
phrase stored in the recorder’s
memory appears in the display.
3
Flip the bar towards x to move the
cursor from the letter input area to the
character palette.
4
Turn the jog dial until the desired
phrase flashes in the display.
Turning the jog dial causes the
phrases stored in the recorder’s
memory to appear one by one in
sequential order.
5
Press the jog dial while the phrase
you want flashes in the display.
The phrase is selected and lights up in
the letter input area.
6
Press the jog dial for 2 seconds or
more.
The phrase is retrieved.
7
If you continue labeling operation, do
steps 5 to 7 of “Labeling recordings”
(page 51).
On the remote control
1 Follow steps 1 to 4 “On the remote control”
in “Labeling recordings” (page 52).
A track, group or disc is ready to be labeled.
2 Press X repeatedly until the phrase stored in
the recorder’s memory appears in the display.
3 Turn the control repeatedly.
Turning the control causes the phrases stored
in the recorder’s memory to appear one by
one.
4 Press x slightly while the phrase you want is
shown in the display.
5 If you continue labeling operation, do steps 5
to 7 of “On the remote control” in “Labeling
recordings” (page 52).