Avocent Cyclades-PR4000 - Manual (Page 137)

137
Cyclades-PR4000
Chapter 14 - Filters and Rules
The configured rules will appear as shown in the following listing.
Note that for this type of traffic control, of the traffic-specific parameters only Flow Priority is used. The Reserved
Bandwidth and Bandwidth Priority parameters are not important. A system needing all three is conceivable, but
much too complicated to show in this manual.
Rules Lists
Rule List
Name
Rule Default List Linked
Status Scope Type Rule
List
web_access Enabled Traffic
Filter_list Name web_access
Rule 0 Rule 1
Status Enabled Status Enabled
Flow priority 1 Flow Priority 2
Rule bandwidth 0% Rule bandwidth 0%
Bandwidth priority 0 Bandwidth priority 0
Protocol TCP Protocol TCP
Source IP Operator None Source IP Operator None
Destination IP
Operator None Destination IP
Operator None
Source Port Operator Equal Source Port Operator None
Source Port Start 80 Destination Port
Operator Equal
Destination Port
Operator None Destination Port
Start SMTP