Avocent Cyclades-PR4000 - Manual (Page 69)

69 Chapter 8 - The E1 and T1 Interfaces, With Signaling
Cyclades-PR4000
Channel ISDN Menu CONFIG=>INTERFACE=>T1/E1(ISDN-PRI)=> <CHANNEL> =>ISDN
or
Channel Signaling Menu CONFIG=>INTERFACE=>T1/E1(CAS)=>
<CHANNEL> =>SIGNALING
Parameter Description
Connection Type Applies only for ISDN. Whether the line will be used to receive (dial-in) or send (dial-out)
messages, or both.
Phone # for this
Channel Applies for Dial-in, or Both. If a specific phone number is assigned to each channel,
enter it here. Usually this does not happen.
Increment By Applies only for CAS, when configuring a range or all channels. Increment by zero
assigns all channels in the range the same phone number (set in the previous item).
Increment by one assigns consecutive phone numbers to all channels in the selected
range.
Digital Modem
Profile ID Applies for Dial-in, or Both. The modem profiles are defined in CONFIG =>SYSTEM
=>MODEMS =>DIGITAL MODEM.
Automatic Dial Out Applies only for ISDN and Dial-out. If Yes, the router will try to connect with the first
destination listed in the dial-out table as soon as the ISDN line is up and synchronized. If
No, the connection will occur only on demand.
Use DSP to Dial
Out Applies only for ISDN and Dial-out or Both. If Yes, the connection will be analog
(modem). If No, digital.
The Authentication Menu Tree, which appears only for PPP and PPPCHAR encapsulation, is shown in Figure 8.3.