Avocent Cyclades-PR4000 - Manual (Page 37)

Cyclades-PR4000
37 Chapter 4 - Step-by-Step Instructions
Example 2 Connection to an Internet Access Provider via Modem
This section will guide you through a complete router installation for the connection of a LAN to an Internet access
provider via PPP. The configuration of NAT (Network Address Translation) will also be shown. Figure 4.6 shows
the example system used in this section. Spaces have been provided next to the parameters needed for the
configuration where you can fill in the parameters for your system. Do this now before continuing.
PC
Host
Host
IP Address
Assigned
Dynamically
RS-232 _ _ _
DSU/CSU
192.168.0.10 _ _ _ _ _ _ _ _ _
192.168.0.1_ _ _ _ _ _ _ _ _
192.168.0.11
192.168.0.30 _ _ _ _ _ _ _ _ _ PR4000
Network
192.168.0.0
FIGURE 4.6 CONNECTION TO ACCESS PROVIDER USING A SWAN INTERFACE AND A MODEM
Please read the entire example and follow the instructions before turning the router on. The router is
programmed to log the super user off after 10 minutes of inactivity. All data not explicitly saved to
memory is then lost. Collecting the data
while configuring the router will likely cause delays and
frustration.