Sony STR-DH740 - Manual (Page 32)

32 GB
This setting is only available if the “Speaker
Pattern” is set to a setting without surround back
and front high speakers.
To set the front speaker
You can select the front speakers you want
to drive.
Be sure to use the buttons on the receiver to
perform this operation.
Press SPEAKERS repeatedly to select
the front speaker system you want to
drive.
You can confirm the selected speakers
terminals by checking the indicator on the
display panel.
* To select “SP B” or “SP A+B”, set the “SB
Assign” to “Speaker B” in the Speaker Settings
menu (page 60).
This setting is not available when headphones are
connected.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you perform the following
during the measurement process:
– Press ?/1.
– Press the input buttons on the remote
control or turn the INPUT SELECTOR
on the receiver.
– Press .
– Press SPEAKERS on the receiver.
– Change the volume level.
– Connect the headphones.
To set up the receiver
manually
See “Adjusting Settings” (page 57).
Note
Indicators Selected speakers
SP A The speaker connected to the
SPEAKERS FRONT A
terminals.
SP B* The speaker connected to the
SPEAKERS SURROUND
BACK/BI-AMP/FRONT
HIGH/FRONT B terminals.
SP A+B* The speaker connected to both
the SPEAKERS FRONT A and
SPEAKERS SURROUND
BACK/BI-AMP/FRONT
HIGH/FRONT B terminals
(parallel connection).
“SPK OFF” appears on the
display panel.
No audio signals are output from
any speaker terminals.
SPEAKERS
Note