Sony STR-DH740 - Manual (Page 77)

77 GB
Ad
dit
iona
l I
n
fo
rm
a
tion
– Depending on the connected
equipment and TV, you may need to
set up the equipment and TV. Refer
to the operating instructions
supplied with each equipment and
TV.
– Change the input of the receiver to
the HDMI input connected to the
equipment.
• Check that the selected digital audio
input jack is not reassigned to other
inputs (page 54).
The left and right sounds are
unbalanced or reversed.
• Check that the speakers and equipment
are connected correctly and securely.
• Adjust the sound level parameters
using the Speaker Settings menu.
Dolby Digital or DTS multi channel
sound is not reproduced.
• Check that the DVD, etc. you are
playing is recorded in Dolby Digital or
DTS format.
• When connecting the DVD player,
etc., to the digital input jacks of this
receiver, make sure the digital audio
output setting of the connected
equipment is available.
• Set “HDMI Audio Out” to “AMP” in
the HDMI Settings menu (page 64).
• You can enjoy High Bitrate Audio
(DTS-HD Master Audio, Dolby
TrueHD), Multi Channel Linear PCM
only with an HDMI connection.
The surround effect cannot be
obtained.
• Make sure you have selected the sound
field for movie or music (page 45).
• Sound fields do not function when
DTS-HD Master Audio, DTS-HD
High Resolution Audio or Dolby
TrueHD with sampling frequency of
more than 48 kHz are being received.
A test tone is not output from the
speakers.
• The speaker cords may not be
connected securely. Check to see if
they are connected securely and cannot
be disconnected by pulling on them
slightly.
• The speaker cords may have short-
circuit problem.
A test tone is output from a different
speaker than the speaker displayed on
the TV screen.
• The speaker pattern set up is incorrect.
Make sure that the speaker
connections and the speaker pattern
match correctly.
When the receiver is in standby mode,
there is no sound output from the TV.
• When the receiver enters into standby
mode, sound is from the last HDMI
equipment selection before you turned
off the receiver. If you are enjoying
other equipment, play the equipment
and perform the One-Touch Play
operation, or turn on the receiver to
select the HDMI equipment you want
to enjoy.
• (For USA, Canada, Mexico, Australia
and Taiwan models only)
Make sure “Pass Through” is set to
“On” in the HDMI Settings menu if
you connect equipment not compatible
with the “BRAVIA” Sync to the
receiver (page 64).
The FM reception is poor.
• Use a 75-ohm coaxial cable (not
supplied) to connect the receiver to an
outdoor FM antennas (aerial) as shown
below.
Tuner