Sony STR-DH740 - Manual (Page 76)

76 GB
There is no sound from a specific
equipment.
• Check that the equipment is connected
correctly to the audio input jacks for
that equipment.
• Check that the cord(s) used for the
connection is (are) fully inserted into
the jacks on both the receiver and the
equipment.
• Check the INPUT MODE (page 54).
• Check that the equipment is connected
correctly to the HDMI jack for that
equipment.
• You cannot listen to the Super Audio
CD by connecting HDMI.
• Depending on the playback
equipment, you may need to set up the
HDMI setting of the equipment. Refer
to the operating instructions supplied
with each equipment.
• Be sure to use a High Speed HDMI
cable when you view images or listen
to sound, especially for the 1080p,
Deep Color (Deep Colour), 4K or 3D
transmission.
• Audio signals (format, sampling
frequency, bit length, etc.) transmitted
from an HDMI jack may be suppressed
by the connected equipment. Check
the setup of the connected equipment if
the image is poor or the sound does not
come out of the equipment connected
via the HDMI cable.
• When the connected equipment is not
compatible with copyright protection
technology (HDCP), the image and/or
the sound from the HDMI TV OUT
jack may be distorted or may not be
output. If this is the case, check the
specification of the connected
equipment.
• Set the image resolution of the
playback equipment to more than
720p/1080i to enjoy High Bitrate
Audio (DTS-HD Master Audio, Dolby
TrueHD).
• The image resolution of the playback
equipment may need to be at certain
settings before you can enjoy Multi
Channel Linear PCM. Refer to the
operating instructions of the playback
equipment.
• Make sure the TV is compatible with
the System Audio Control function.
• If the TV does not have System Audio
Control function, set the “HDMI
Audio Out” settings in HDMI Settings
menu to
– “TV+AMP” if you want to listen to
the sound from the TV speaker and
receiver.
– “AMP” if you want to listen to the
sound from the receiver.
• When you connect the receiver to a
video equipment (projector, etc.),
sound may not be output from the
receiver. In this case, set the “HDMI
Audio Out” to “AMP” in the HDMI
Settings menu (page 64).
• If you cannot listen to the sound of the
equipment connected to the receiver
while TV input is selected on the
receiver
– Be sure to change the input of the
receiver to HDMI when you want to
watch a program on the equipment
connected via HDMI connection to
the receiver.
– Change the TV channel when you
want to watch a TV broadcast.
– Be sure to select the correct
equipment or input you want when
you watch a program from the
equipment connected to the TV.
Refer to the operating instructions of
the TV on this operation.
• Check that the “Analog Direct” is not
being used.
• When using the Control for HDMI
function, you cannot control the
connected equipment using TV’s
remote control.