Sony STR-DH740 - Manual (Page 56)

56 GB
Using a bi-amplifier
connection
1
Press HOME.
The menu is displayed on the TV
screen.
2
Select “Settings”, then press .
The Settings menu list appears on the
TV screen.
3
Select “Speaker”, then press .
4
Select “Speaker Pattern”, then
press
.
5
Select the appropriate speaker
pattern so that there are no
surround back speakers and front
high speakers, then press
.
6
Select “SB Assign”, then press
or b .
7
Select “Bi-Amp”, then press .
The same signals output from the
SPEAKERS FRONT A terminals can
be output from the SPEAKERS
SURROUND BACK/BI-AMP/
FRONT HIGH/FRONT B terminals.
To exit the menu
Press HOME to display the home menu,
then press HOME again.
• Set the “SB Assign” to “Bi-Amp” before you
perform Auto Calibration.
• If you set the “SB Assign” to “Bi-Amp”, the
speaker level and distance settings of the
surround back speakers and front high speakers
become invalid, and those of the front speakers
are used.
Reverting back to the
factory default settings
You can clear all memorized settings and
revert the receiver back to the factory
default settings by performing the
following procedure. This procedure can
also be used to initialize the receiver before
you use it for the first time.
Be sure to use the buttons on the receiver to
perform this operation.
1
Press ?/1 to turn off the receiver.
2
Hold down ?/1 for 5 seconds.
The “CLEARING” appears on the
display panel for a while, then changes
to “CLEARED!”.
Changes or adjustments made to the
settings are now reset to the defaults.
Notes
? /1