Sony STR-DH740 - Manual (Page 64)

64 GB
x D.Range Comp. (Dynamic
Range Compression)
Lets you compress the dynamic range of
the soundtrack. This may be useful when
you want to watch movies at low volumes
late at night. Dynamic range compression
is possible with Dolby Digital sources only.
• On: The dynamic range is compressed as
intended by the recording engineer.
• Auto: The dynamic range is compressed
automatically.
• Off: The dynamic range is not
compressed.
HDMI Settings menu
You can adjust the required settings for
equipment connected to the HDMI jack.
x Control for HDMI
Lets you turn the Control for HDMI
function on or off. For details, see
“Preparing for the “BRAVIA” Sync”
(page 50).
• On
• Off
• When you set “Control for HDMI” to “On”,
“HDMI Audio Out” may be changed
automatically.
• When the receiver is in standby mode, the ? /1
(on/standby) indicator on the front panel lights
up in amber if “Control for HDMI” is set to
“On”.
x Pass Through
Lets you output the HDMI signals to the
TV even when the receiver is in standby
mode.
• On*: When the receiver is in the standby
mode, the receiver continuously outputs
HDMI signals from the receiver’s HDMI
TV OUT jack.
• Auto: When the TV is turned on while
the receiver is in the standby mode, the
receiver outputs HDMI signals from the
receiver’s HDMI TV OUT jack. Sony
recommends this setting if you use a
“BRAVIA” Sync compatible Sony TV.
This setting saves power in the standby
mode when compared with the “On”
setting.
This setting can only work when “Control for
HDMI” is set to “On”.
• Off: The receiver does not output HDMI
signals when in standby mode. Turn on
the receiver to enjoy the connected
equipment’s source on the TV. This
setting saves power in the standby mode
when compared with the “On” setting.
* For USA, Canada, Mexico, Australia and
Taiwan models only.
When “Auto” is selected, it may take a little more
time for the image and sound to be output to the
TV than when “On” is selected.
x HDMI Audio Out
Lets you set the HDMI audio signals output
from the playback equipment connected to
the receiver via an HDMI connection.
• AMP: The HDMI audio signals from the
playback equipment are only output to
the speakers connected to the receiver.
Multi channel sound can be played back
as it is.
Audio signals are not output from the TV’s
speaker when “HDMI Audio Out” is set to
“AMP”.
• TV+AMP: The sound is output from
TV’s speaker and the speakers connected
to the receiver.
• The sound quality of the playback equipment
depends on the TV’s sound quality, such as
the number of channels, and the sampling
frequency, etc. If the TV has stereo speakers,
the sound output from the receiver is also in
stereo as that of the TV, even if you play back
multi channel source.
Notes
Note
Note
Note
Notes