Name of each part, O.k. out, Remote control – Panasonic SA24CTP User Manual
Page 5
4
NAME OF EACH PART
■ Remote Control
● Remote Control Signal.
• Make sure it is not obstructed.
• Maximum distance : 10 m.
• Signal received sound.
One short beep or one long beep.
● Notes for Remote Control.
• Do not throw or drop.
• Do not get it wet.
• Certain type of fluorescent lamps may affect
signal reception. Consult your dealer.
● Do not place the remote control in a location exposed
to direct sunlight, or next to a heating unit, or other
heat source.
● How to Insert the Batteries
1
Gently press the place marked OPEN and slide
the cover towards you.
2
Insert the batteries
– Be sure the direction is correct.
● About the batteries
• Can be used for approximately one year.
● Observe the following when replacing the batteries
• Replace with new batteries of the same type.
• Do not use rechargeable batteries (Ni-Cd).
• Remove the batteries if the unit is not going to be
used for a long period.
● Proper way to operate the remote control in the
case of ceiling/wall mounting.
• Operate the remote control in parallel with the floor.
(See the figure below)
1 Signal Transmitter
2 Operation Display
3 Room Temperature Setting Button
(Illuminating button)
4 Operation Mode Selection Button
5 Sleep Mode Operation Button
(Illuminating button)
6 Timer Setting Button
7 Timer Selection Button
8 OFF/ON Button
(Illuminating button)
9 Fan Speed Selection Button
0 Auto Airflow Direction Button
! Timer Set/Cancel Button
@ Manual Airflow Direction Selection Button
# Reset Point
(Press with fine-tipped object to clear the memory)
1.5V
1.5V
OPEN
1
2
AUTO
HEAT
COOL
DRY
FAN
SPEED
H
H
OFF
OFF
ON
ON
A
B
AUTO
COOL
DRY
FAN
FAN
SPEED
H
H
OFF
OFF
ON
ON
A
B
Cooling Model
Heat Pump Model
"
!
#
$
3
5
7
6
8
9
4
1
OFF/ON
TEMP
MODE
SLEEP
FAN SPEED
AUTO
MANUAL
TIMER
AIR SWING
SELECT SET/CANCEL
RESET
A
B
AUTO
HEAT
COOL
DRY
FAN
AN
SPEED
SPEED
H
H
OFF
OFF
OFF
OFF
ON
ON
ON
ON
A
B
2
• The signal changes as shown in the figure below.
It means that the receiving conditions are bad and
the signal can not be controlled properly.
O.K.
OUT
(Fig. 2)
(Fig. 1) Horizontal Level
12CTP5-01EN(01-09)
12/24/09, 11:29 AM
4