AEG LAVAMAT 88730 - Manual (Page 31)

Operating Instructions
31
What to do if...
Trouble Shooting
If the appliance is not working correctly, please carry out the following
checks before contacting your local Service Force Centre. Important: If
you call out an engineer to a fault listed below or to repair a fault
caused by incorrect use or installation, a charge will be made even if
the appliance is in guarantee.
• If the fault code C1 oder C2 is shown in the
multi-display, you may be able to remedy
the fault yourself (see the Fault table be-
low).
After clearing the fault, press the START/PAUSE button. If the fault
code is shown again, contact your local Service Force Centre.
• For all other faults displayed in the multi-display, please contact your
local AEG Service Force Centre, stating the fault code.
Problem Possible Cause Remedy
The washing machine
does not work.
The mains plug is not
plugged in.
Plug in the mains plug.
The house fuse has blown. Replace the fuse.
The door is not correctly
closed. Close the door; The lock must
engage audibly.
START/PAUSE button not
pressed long enough.
Keep the START/PAUSE but-
ton pressed until the pro-
gramme begins.
The door cannot be
closed.
The child safety feature is set
Cancel the child safety fea-
ture (see Section "Child
Safety Feature“).
Water is not running.
Error code
(1
ap-
pears.
Water tap closed. Open the water tap.
Filter in screw connection of
the inlet hose is blocked.
Close the water tap. Unscrew
the hose from the tap, re-
move the filter and clean un-
der running water
Water tap is blocked with
limescale or is faulty. Check water tap and have it
repaired if necessary.