AEG LAVAMAT 88730 - Manual (Page 32)

Operating Instructions
32
The washing machine
vibrates during opera-
tion or is unstable.
The transport packaging has
not been removed.
Remove transport packaging
according to the installation
and connection instructions.
The machine is not level.
Adjust the feet according to
the installation and connec-
tion instructions.
There is very little washing in
the drum (e.g. only one
dressing gown).
This does not impair the
function.
The water could not be com-
pletely pumped out before
spinning because the drain-
age hose is kinked or
the drain pump is blocked.
Check the drain hose and re-
move any kink if necessary,
or clean the drain pump and,
if required, remove foreign
bodies from the pump hous-
ing.
Excessive foaming dur-
ing the main wash. Probably too much detergent
was used.
Measure the detergent ex-
actly in accordance with the
manufacturer's information.
Water runs out from
under the washing ma-
chine.
The screw connection on the
inlet hose is leaking. Tighten the inlet hose screw
connection.
The drainage hose is leaking.
Check the drainage hose and
replace it if necessary.
The drain pump cover is not
correctly closed.
Close cover correctly.
Washing is caught in the
door.
Stop the programme, remove
the washing caught in the
door. Restart the programme.
The emergency emptying
hose is not correctly closed
or is leaking.
Close the emergency empty-
ing hose correctly (see the
section "Carry out emer-
gency emptying“). Call your
local Service Force Centre if
the emergency emptying
hose leaks.
Problem Possible Cause Remedy