AEG LAVAMAT 88730 - Manual (Page 33)

Operating Instructions
33
The drain pump for the
washing machine runs
constantly - even when
the appliance is
switched off.
The Aqua Control anti-flood
system has been activated.
Turn off the tap, then re-
move the plug from the
mains and inform Customer
Service.
Fabric softener was not
rinsed in, compart-
ment
æ for condition-
ers is filled with water.
The conditioner insert in the
compartment for the condi-
tioner is not correctly at-
tached or is blocked.
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Washing heavily
creased Probably too much washing
put in the drum.
Pay attention to the maxi-
mum load quantity (see Pro-
gramme tables). In the case
of easy-care fabrics, select
the EASY IRON programme.
The washing is not suf-
ficiently spun. Water is
left in the drum.
Error code
(2
appears
.
Drain hose is kinked. Remove the kink.
Maximum pump head (dis-
charge height 1m from the
unit's floor) is exceeded.
Contact your local Service
Force Centre. For pumping
heights over 1m a conver-
sion kit is available as a spe-
cial accessory.
Drain pump blocked.
Switch off the appliance and
pull out the mains plug.
Clean the drain pump.
The door cannot be
opened when the ap-
pliance is switched on.
The door is locked for safety
reasons (DOOR/LIGHT display
is off).
Wait until the DOOR/LIGHT
display lights up green.
The programme protection
function is set.
Cancel programme protec-
tion (see the section "Pro-
gramme protection“).
Remnants of detergent
are building up in the
detergent drawer.
Water tap not fully opened. Open the water tap fully.
The inlet hose filter in the
coupling of the inlet hose at
the tap is blocked.
Close the water tap. Unscrew
the inlet hose from the water
tap and the appliance and
clean the filter.
The rinsing water is
cloudy.
The cause is probably a de-
tergent with a high silicate
content. No negative influence on the
rinsing results, use a liquid
detergent if necessary.
Problem Possible Cause Remedy