AEG LAVAMAT 88730 - Manual (Page 43)

Installation and connection instructions
43
3 The special spanner (A) and the
caps (B) (2 each) and (C) (1 each)
are supplied with it.
3. Remove the screw D, including
the compression spring with the
special spanner A.
4. Cover the hole with the cap C.
Important! When fitting the
plastic caps, press until they snap
into the rear panel securely.
5. Remove the two screws (E) with
the special spanner (A).
6. Remove the 4 screws (F).
7. Remove the transit bar (G).
8. Screw the 4 screws (F) back in for
safe keeping.
9. Close the 2 large holes with the
caps (B).
Important! When fitting the
plastic caps, press until they snap
into the rear panel securely.