Alloy Computer Products GSM-8T16SFP - Manual (Page 118)

GSM Series User Manual
114
Alloy Computer Products Pty Ltd Copyright ©2006
4. Operation of CLI Management
4-1. CLI Management
Refer to chapter 2 for basic installation.
When configuring the GSM Series switches via the RS-232 console please connect the switch
via the provided serial cable to a DCE device such as a PC. Once you have connection run a
terminal emulation program such as Hyper Terminal. When connecting to the switch please use
the serial settings of the switch to create the connection, the default settings are below:
Baud Rate: 57600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
The same interface can also be accessed using Telnet.
The default IP Address, Subnet Mask and Gateway addresses are shown below:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.254
Open a command prompt and telnet to the default IP address shown above.
4-1-1. Login
The command line interface (CLI) is a text based interface, users can access the CLI through
either a direct serial connection to the device or a Telnet session. The default username and
password for the device is shown below:
Username: admin
Password: admin
After you have logged in successfully the prompt will be shown as “#” meaning that you are the
first to login to the switch with administrator rights. If a “$” prompt is shown it means that you
have logged in as a guest and you are only allowed to view the system, no changes can be made
to the switch.