Panasonic TH65PF12EK - Manual (Page 27)

27
Picture Adjustments
Notes:
• “Colour” and “Hue” settings cannot be adjusted
for “RGB/PC” input signal.
• You can change the level of each function
(Contrast, Brightness, Colour, Hue, Sharpness)
for each Picture Mode.
• The setting details for normal, dynamic and
cinema respectively are memorized separately
for each input terminal.
• The “Hue” setting can be adjusted for NTSC
signal only during “AV (S Video)” input signal.
• In Contrast, there is not a noticeable change
even when contrast is increased with a bright
picture or reduced with a dark picture.
Advanced settings
On the remote control unit, while the “Advanced settings” menu is displayed, if either the N button is pressed at any time or
the ACTION ( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.
Helpful Hint ( / Normalise Normalisation)
Item Effect Adjustments
Contrast
Less
More
Selects the proper brightness
and density for the room.
Brightness
Darker Brighter
Adjusts for easier viewing of
dark pictures such as night
scenes and black hair.
Colour
Less More
Adjusts colour saturation.
Hue
Reddish Greenish
Adjusts for nice skin colour.
Sharpness
Less More
Adjusts picture sharpness.
Notes:
• Carry out “W/B” adjustment as follows.
1. Adjust the white balance of the bright sections using the “W/B High R”, “W/B High G” and “W/B High B” settings.
2. Adjust the white balance of the dark sections using the “W/B Low R”, “W/B Low G” and “W/B Low B” settings.
3. Repeat steps 1 and 2 to adjust.
Steps 1 and 2 affect each other’s settings, so repeat each step in turn to make the adjustment.
• The adjustment values are memorized separately for each input terminal.
• The adjustment range values should be used as an adjustment reference.
Item Effect Details
Black
extension
Less More
Adjusts the dark shades of the image in gradation.
Input level
Less More
Adjustment of parts which are extremely bright and hard to see.
Gamma
Down Up
S+ Curve* 1 S Curve 2.0 2.2 2.5 2.6* 2
*1 When “Picture Mode” is set to “Dynamic”, Gamma “S+ Curve” can be selected.
When 2k1k signals are received with the Dual Link HD-SDI Terminal Board
(TY-FB11DHD), “S+ Curve” cannot be selected.
*2 When 2k1k signals are received with the Dual Link HD-SDI Terminal Board
(TY-FB11DHD), Gamma “2.6” can also be selected.
AGC
Off On
Increases the brightness of dark signal automatically.
W/B High
R
Less More
Adjusts the white balance for light red areas.
W/B High
G Less More
Adjusts the white balance for light green areas.
W/B High
B Less More
Adjusts the white balance for light blue areas.
W/B Low R
Less More
Adjusts the white balance for dark red areas.
W/B Low G
Less More
Adjusts the white balance for dark green areas.
W/B Low B
Less More
Adjusts the white balance for dark blue areas.