Panasonic TH65PF12EK - Manual (Page 50)

Sync Auto
Sync on G
Sync VBS
H-Freq.
V-Freq. kHz
Hz 63.98
60.02
Signal Format 1280×1024/60
Sync
Signal [ RGB ]
Cinema reality
XGA Mode
Auto
Off
Auto
H-Freq.
Dot Clock Freq.
kHz
MHz
63.98
108.0
V-Freq. Hz 60.02
Signal Format 1280×1024/60
50
Select Signal from the “Setup” menu during RGB input signal.
Setting RGB sync signal:
Confi rm that the input is set to RGB input (this setting is valid only for RGB input signal).
Auto: The H and V sync or synchronized signal are automatically selected.
If both input, it is selected the H and V sync.
on G: Uses a synchronized signal on the Video G signal, which is input
from the G connector.
VBS: Uses a synchronized signal of Composite Sync input, which is input
from the HD connector.
Sync
Setup for Input Signals
Press to select the “Sync”.
Press to adjust.
Displays the frequency and the type of the current input signal.
This display is valid only for Component / RGB / PC and Digital input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical 48 - 120 Hz
The dot clock frequency is displayed during digital signal input.
Input signal display
Cinema reality
Signal
Off
Noise reduction Off
[ Digital ]
SDI Through Off
Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board
(TY-FB11DHD) is selected.
SDI Through
Press to select the “SDI Through”.
Press to select “On” or “Off”.
On: Enables active through.
Off: Disables active through.