IPricot IPR-S1000 - Manual (Page 10)

Installing the IPR-S1000
5
III Installing the IPR-S1000
1. Connecting the cables
The appropriate cables are necessary to connect the IPR-S1000 to the
Ethernet network as well as to the satellite antenna. Refer to the
following list and illustrations to correctly locate the different
connectors.
Connectors
- Ethernet 10/100 Mbps RJ45 connector
- Coaxial satellite connector, F type.
- DB-9 serial connector (console / modem).
Making the connection
Note: To help you making the connection, refer to the illustration on
the next page.
- Inserting the Multimedia Card (MMC)
Before inserting the MMC into the slot, make sure the card is correctly
oriented. The right notch of the MMC must be directed towards the slot.
Note: If the MMC is not properly inserted, the unit will not boot and
the LCD screen will say «IPR-S1000, Booting: Wait...».
- Connecting to the Ethernet network
Connect an Ethernet cable to the Ethernet connector.
Note: For better results, use a Shielded Twisted Pair (STP) category
5 cable.
- Connecting to the satellite antenna
Connect the satellite antenna using the F type connector on the back
of the equipment.
Note: Make sure the cable is inserted and secured by tightening the
connector.
- Connecting the power cord
Connect the power cord.
Do not extract the MMC when the power is ON. It can
cause damage to the equipment.